This is a lag screw.
|
Size: |
1/4in |
|
Length: |
4in or 6in |
|
Colors: |
Zinc |
|
Finish: |
Zinc |
|
Common Uses: |
The 4in lag screw is typicaly used for a hanger to wall connection when no ledger board is present. The 6in lag may be used for a ledger to wall connection. |
|
Helpful Tips: |
Lag screw may need to embed the stud of the house at least 2 inches. |
|
Reminders: |
This may not be sufficient for studs spaced more than 16 inches on center. See local building codes for approval in your area. |
|
Instructions: |
Drive Lag through the hanger or ledger and wall of the house and into the studs. |
|
Shipping: |
This product can be picked up for free at any of the Amerimax factories. Factories are located in Sacramento, CA 95834, Romoland, CA 92585, Las Vegas, NV 89030, and Phoenix, AZ 85043. It can also be shipped via UPS Ground. Please call us if you are combining this product with one of our large products that must ship freight. In checkout it will try to split the order into two shipments but if you call us we can save you shipping costs by adding this product to the freight shipment. |
|
Qualifications: |
The measurements indicated are approximate and may not be exact. If exact measurements are needed please refer to the engineering. The engineering and information on this site is for your reference only. Absolute Carports recommends that you get your plans and this engineering approved by your local building department before you purchase. |
|