This is bracket made of extruded Aluminum. The bracket fits inside a rafter and is used for attaching one end of a rafter to a ledger board.
|
Size: |
2in x 6in or 3in x 8in |
|
Thickness: |
0.060in |
|
Colors: |
Mill Finish |
|
Common Uses: |
This bracket is used for making ledger board to rafter attachments. |
|
Reminders: |
This bracket will go on the inside of the rafter or header. |
|
Related Items: |
Screws do not come with brackets. |
|
Instructions: |
Bolt the braket into position on the ledger board. Then slide the rafter over the flanged ends and secure with fasteners starting form the outside and going in. |
|
Shipping: |
This product can be picked up for free at any of the Amerimax factories. Factories are located in Sacramento, CA 95834, Romoland, CA 92585, Las Vegas, NV 89030, and Phoenix, AZ 85043. It can also be shipped via UPS Ground. Please call us if you are combining this product with one of our large products that must ship freight. In checkout it will try to split the order into two shipments but if you call us we can save you shipping costs by adding this product to the freight shipment. |
|
Qualifications: |
The measurements indicated are approximate and may not be exact. If exact measurements are needed please refer to the engineering. The engineering and information on this site is for your reference only. Absolute Carports recommends that you get your plans and this engineering approved by your local building department before you purchase. |